Igashuk Shrine

Maren's Tip

Remember — if a shrine gives Rauru's Blessing with no puzzle inside, the real challenge was reaching the entrance. Check the surrounding area!

Walkthrough

1. Step 1: Enter Igashuk Shrine in the Rimewise region.
2. The theme is Orb on Incline — assembling a continuous downhill track from modular rail pieces so gravity can roll a metal orb into a target socket.
3. A metal orb sits at the top of a starting ramp, and the target socket is below-left of the starting position, separated by a gap that the orb cannot cross without a properly constructed rail path.
4. Step 2: Four modular rail pieces are scattered around the room, each a curved or straight metal track segment.
5. These must be connected end-to-end to form a continuous downhill path from the orb's starting ramp to the socket's inlet.
6. Examine each piece — they have male and female connection points at their ends that must align for the orb to roll smoothly between segments.
7. Step 3: Rail 1 connects to the starting ramp but is rotated 30 degrees off-axis.
8. Use Ultrahand to grab it and rotate it 30 degrees clockwise until its male end clicks into the ramp's female outlet.
9. The rail should angle downward and to the left.
10. Step 4: Rail 2 is placed backwards — its male end faces the wrong direction.
11. Grab it with Ultrahand and flip it 180 degrees (rotate it end-over-end, not side-to-side).
12. Attach its female end to Rail 1's male outlet.
13. The track now curves further left and downward.
14. Step 5: Rail 3 is already in the correct orientation — grab it and slide it into position connecting Rail 2's outlet.
15. The track now runs in a gentle S-curve heading toward the socket area.
16. Step 6: Rail 4 is the final piece connecting to the socket inlet, but it sits about 20 centimeters too high.
17. Use Ultrahand to lower it precisely so its outlet end aligns with the socket's inlet hole.
18. The connection must be flush — even a small misalignment causes the orb to derail and fall off the track at the junction.
19. Step 7: Once all four rails form a continuous downhill path, nudge the metal orb off its starting pedestal with Ultrahand or a melee tap.
20. Gravity takes over — the orb rolls down Rail 1, curves through Rails 2 and 3, drops through Rail 4, and seats into the socket with a satisfying metallic click.
21. The altar gate opens.
22. Step 8: Claim the Light of Blessing.
23. A chest near the socket area contains an Opal (worth 60 rupees).
24. Abilities needed: Ultrahand (rail manipulation, orb nudging).
25. Pro tip: If the orb derails at a junction, the connection is misaligned.
26. Pick up the orb with Ultrahand and set it back on the starting pedestal.
27. Then fine-tune the problem junction — zoom in with Ultrahand and use micro-adjustments rather than large rotations.

Reward & Chest

More Shrines in Rimewise

• Gadathor Shrine — Puzzle, difficulty 2/5
• Kogyah Shrine — Combat, difficulty 2/5
• Maka Rah Shrine — Rauru's Blessing, difficulty 1/5
• Makurukis Shrine — Puzzle, difficulty 2/5
• Mayam Shrine — Combat, difficulty 4/5
• Runakit Shrine — Rauru's Blessing, difficulty 1/5

Related Guides

• All 152 Shrines
• Shrine Quests
• Skyview Towers
• Lightroots
• Deep Walkthrough Guide